Question: How do I set up iClicker with the instructor remote and base?
Open the iClicker home menu and highlight the course that you want to set up. Select Settings to connect the instructor remote. If you need to create a course you can follow the instructions on the iClicker Startup page.
Under the General tab, input the Instructor Remote ID found at the bottom on the back of the remote. Note: This only needs to be done once for each course. You can use the same instructor remote for multiple courses.
Connect the iClicker base to your computer by using the cord provided by The Teaching Center.
Navigate back to the iClicker home menu which will now have two more options available. Highlight the course you wish to use by clicking on it. Select Start New Session.
Once you have started a session, a small pop-up toolbar will appear on your computer screen. The base will appear as shown below.
Turn on your instructor remote. A message will appear instructing you to select the AA frequency. Follow the prompt to key in the base frequency upon turning on the remote. This is the default frequency and can be changed. To change the frequency follow the instructions on the Change the Frequency page. It is recommended that you use the default frequency. Note: If you have already set your instructor remote to the AA frequency, you do not need to set it again. You can simply close out of this screen.
On the instructor remote, each letter corresponds to an action. To learn more about these actions follow the instructions on the Use the Instructor Remote page.